|
Mossberg 930 Tactical Shotgun Review In this part of my Mossberg 930 Tactical Shotgun Review, I show all of the internal features of this shotgun. Since there are over 100 photos below, I don't comment on each photo, but have provided them so you can study them yourselves and form your own opinions on what you see.
Receiver Assembly Although further disassembly is possible for the receiver shown below, I decided this level of disassembly was far enough to show the internal features. The magazine tube is threaded into the receiver and I was able to start unscrewing the tube slightly, but after a turn, the torque unscrews increased significantly so I decided to leave well enough alone since I hadn't had a chance to range test the shotgun. These next two photos show the receiver without and then with a stock shim in place. Trigger Housing Assembly Trigger Housing Pins Link & Link Pin Slide Assembly Bolt Assembly Operating Handle Forearm Retainer Gas System Return Spring Pusher Assembly Gas Piston Spacer Tube Gas Piston Assembly and Seal Ring Barrel Assembly Magazine Cap Assembly Buttstock Stock Nut Spacer Stock Nut Recoil Pad & Screws Magazine Follower Magazine Spring Magazine Cap Detent Magazine Spring Retainer Forearm
Thoughts I need to spend more time shooting guns and not my camera. For more detailed photos and commentary, make sure you check out the other parts of this review and feel free to leave comments on my Reader's Comments page. The following links are provided to help you see other parts of this review.
Or If you would like to be notified about future Gunsumer Reports reviews via Facebook, make sure "You Like This" by clicking the Facebook "Like" button at the bottom or top of this page. If it already says "You Like This" beside the button, clicking it again will uncheck the "Like" status and you will not be notified.
|
||||
© 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023 & 2024 Gunsumer Reports™, All rights reserved. FTC Disclosure |